Hello,
- configuration : Version 1.2.184 / W10
-It was not the case a year or several months ago, but now when I try to find the area that I would like to cut, it happends most of the time that TS Doctor stops to work and I have to start again from zero.
It seems to depend on the speed to go from one point to the other. If if I move very slowly nothing happens but I if I move a bit faster the problem appears.
Thanks in advance
Yes Windows 10 is a pain in the ass. Try to install free LAVFilters instead using the Microsoft filters. Windows 7 was the last "good" OS with reliable video decoders.
Under Settings/Preferences/Supported tools/LAVfilters you can install the free reliable filters.
Thanks for your answer.
I try to re-install LAV filters ( using "supported tools) but I got a message : " This program requires Windows service pack 3 or later" ???
Service pack 3 for Windows 10?
Do you use the XP compatibility mode or something like that ?
Hi,
- I do not think so, previously I used W7 before W10 and I don't know how to check that (not shown in system parameters)..
- I checked that Lav filters are already installed ( 0.68.1 )
Any other idea to avoid crash ?
OK, if LAVs are installed, just ignore that.
After the next crash, please go to Settings/Preferences/Preview , click on "Show DirectX Log" and post that log. Maybe I can see what filters are used for the preview and at what point the crash happens.
Hi,
- OK, see attached log
- I shall say too that the problem occurs most of the time when using the scrollbar ( as said depends on the speed to move it)
but If I use the buttons ( 1 mn, 10s,1s etc.) it works ( until now !).
Looks OK. Try to disable "Use fast sample grabbing" under Settings/Preferences/Preview.
After 2 trials on a record presenting that problem, seems OK.
I am crossing my finger and will let you know if problem appears again.
Thanks again